CalcGallery

Flagstone Calculator

Turn a patio or path area into tons of flagstone at your supplier’s coverage, plus the base material to lay beneath it.

Built by AbhiLast reviewed November 6, 2026

Units
Area to pave

Your measurements

Add one row per section of the patio or path.

Ask your supplier for this stone at this thickness. Thin stone covers more than thick stone.

Optional. The depth of gravel or sand you will lay under the stone.

Result

Enter area to pave and coverage per ton or tonne to see the result.

Your entries are kept on this device only.

Results are estimates for planning only. Actual needs vary with site conditions, products and workmanship. Always confirm quantities with your supplier and follow local building codes and manufacturer instructions. Read the full disclaimer

How to use the Flagstone Calculator

  1. Add each section of your patio or path as a row.
  2. Ask your supplier what this stone covers per ton at the thickness you want, and enter it.
  3. Enter a base depth if you are laying gravel or sand under the stone.
  4. Order the stone by weight, with the extra allowance included.

The sum

Weight = area × (1 + allowance) ÷ coverage per tonBase   = area × base depth

There is no single right coverage figure, which is why the page asks for yours. Treat any general number you see online with care: two yards selling the same stone can quote different coverage, and the joints you leave also change it.

Choosing and sorting stone

Look at a pallet before you buy, since one lot can vary in colour and thickness. Spread the stone out and lay the large pieces first, then fill in with smaller ones. A wider joint stretches the stone further, but it needs more jointing material.

Scope

This covers quantities only. Base depth, drainage, frost and how level the ground is all depend on your site.

With your numbers

  1. Area with 5% extra, divided by 100 ft² of cover per ton
  2. Order 2.1 ton

Quick reference

Irregular stone needs cutting and sorting, so a little extra saves a second delivery.

Common jobs, worked out with the options this calculator starts on for United States.
JobFlagstone to order
200 ft² patio at 100 ft² a ton2.1 ton
120 ft² patio at 150 ft² a ton0.84 ton
300 ft² patio at 80 ft² a ton3.94 ton
30 ft path, 3 ft wide0.95 ton
L-shaped patio1.97 ton
18 m² patio at 10 m² a tonne1.89 t
10 m path, 1 m wide0.88 t

Where the numbers come from

The fixed figures this calculator relies on, and the published source each one was checked against. How the calculators are built and checked

1 source
  1. Brick Industry Association, Technical Note 10 "Dimensioning and Estimating Brick Masonry" (Feb 2009), Brick breakage and waste: add at least 5%, https://gobrick.com/media/file/10-dimensioning-and-estimating-brick-masonry.pdf

    Used for

    • Brick or block allowance: 5% extra

Common questions about the Flagstone Calculator

How much area does a ton of flagstone cover?
It depends on the stone and its thickness, so ask your supplier. Thin stone covers much more than thick stone, and figures differ between yards.
How many tons do I need for a 200 square foot patio?
At 100 square feet a ton, 200 square feet needs 2 tons, or 2.1 tons with a 5% allowance. A different stone changes that, so use your own coverage.
Why is flagstone sold by weight?
Natural slabs vary in shape and thickness, so a yard weighs them rather than counting them. You turn that into area using coverage per ton.
What base should I use?
That depends on your ground, climate and whether the stone is dry-laid or mortared. This page works out the volume once you pick a depth.

Report a problem with this calculator